For Service Call: (503) 579-2964


Home » Bathroom Plumbing » Steps To Clear Your Plumbing Lines With An Air Compressor

Steps To Clear Your Plumbing Lines With An Air Compressor

Are your plumbing lines clogged up? It happens with older properties, and you have to use an air compressor to bring them back to order. Too many people ignore this and are left with a horrid situation where the plumbing lines are not kept as clear as they need to be. You have to look into making sure the right steps are being taken as they will stand out and make you feel better about what is going on.

Here are the steps to follow to make sure your plumbing lines are fine.

1) Preparatory Work

You want to start with the basics, and that is to prep the property for what is going to be done.

You want to shut off the water supply by turning your water valves.

You are going to attach a hose to the sill cock and drain out all remaining water. This is done through the faucet in your basement.

You also want to make sure you are flushing the toilets to get lingering water out of the pipes. Do this by starting at the top rather than at the bottom of your house.

Close the faucets after you have done this. You are now ready to go to the next step.

2) Use Air Compressor

This is when you are going to use the air compressor as that is key. You are going to connect the air compressor to the sill cock/basement faucet and put it on 70 PSI. This is going to be used to remove the clog that is present. Make sure you have a high quality air compressor like this one: bostitch cap1512 of review. It will do just fine for this type of work.

3) Run Water

Move onto running the hot/cold water through the faucet to get things moving.You need to turn on the dishwasher at this point and let it run. This will continue to pump out the remaining water in the pipes.

Do this with all of your appliances as that is key.

4) Pour Propylene Glycol

You are now going to pour propylene glycol into the sink and tub trap.

Do this gently, so you can get things moving along at a good pace.

This is the finalizing part of your unclogging.

5) Drain Water

The last step is going to be draining water from the piping. You are going to get the water out of the boiler and into the bucket. Plus, you are going to be looking to pump the propylene glycol into the piping as required. This is the only way to make sure everything is cleared out, and you don’t have clogged piping minutes later.

These are the steps you want to consider when you are thinking about clearing your plumbing lines. There are too many people who have the right equipment such as the air compressor but don’t know what to do with it and that can be useless. To make sure you are taking the right steps, you want to follow what has been written in this read. It will ensure you make the right choices.

Leave a Reply

Your email address will not be published. Required fields are marked *